Conta-clip EMS-2-Plotter-System Manual de usuario

©EMS-2Operating InstructionsRelease: March 12, 2012EMS-2Easy-Marking-System

6. Cleaning and product careProtect the EMS-2 from dust and other dirt. When not in use, cover the plotter. A special cover is available as an accesso

7. AccessoriesPlotter Pen-RInk CartridgesPlotter Pen-Davailable in six tip-widthsavailable in six tip-widthsCleaning SetPen Cleaner Cleaning FluidDust

8. TroubleshootingIf your plotter EMS-2 is not functioning correctly, please check the following:Device fails to switch on Check whether the mains plu

9. Technical InformationEMS-2 plotter specificationsType of plotter: Flatbed plotterMaximum plotting area: A3: 440 mm x 305 mm, A4: 220 mm x 305 mmPlo

10. Instructions for packaging the plotter EMS-2two corner pieceswith inlaytwo corner pieceswithout inlaycenter piece coveringthe y-arminside the whit

11. Safety instructionsSafety instructions●Keep the operating instructions in a safe place.●This device complies with all recognised technical standar

Instructions de sécurité●Conserver ces instructions dans un endroit sûr.●Cet appareil répond aux normes techniques et satisfait toutes les règles de s

1. Introduction...22. Items supplied ...

1. Introduction:Thank you for purchasing the EMS-2, a flexible plotter that helps you label markingelements quickly and easily.Rugged construction in

2. Items suppliedPlease check you have received all the items supplied with your labelling device(see list below).Please retain the packaging in case

3. Product overview1) Plotting area2) Pen station3) Sealed storage holders in pen station4) Start-up writing area5) Pin stops for fixtures6) Vacuum su

4. Setting up the Plotter EMS-2LOCATIONA dry, dust-free room is the ideal environment for the plotter. If possible, do not installthe device in damp o

5. OperationOnce you have installed the EMS-2 and connected the power supply and data cable,you can switch the plotter on.Important:Before switching t

Open/close pen stationBefore using the EMS-2, insert the plotter pen with the desired tip width into the penstation.Important:Only plotter pens of the

Placing the fixtures on the PlotterThere are eight pin stops on the plotting area where up to four different fixtures can beloaded. Different fixtures